The final part of this commission build is to create eight barriers for my client to position where ever he would want them. The barriers are made from 10 mm foam board, each one cut to 5 inch in length and 2 inch high (not including the base). The base of each I have gone a quarter of an inch in, using a sharp blade I have cut diagonally across both sides to create a ramp (mind your fingers!)
With the 5 x 2" blocks, I have scored them on both sides at 2.5" from top to bottom, making them look like they are two slabs joined together. In the centre of each slab a rectangular hole has been pressed in on either side.
So far I have created three of these, I aim to have the last five made by then end of the week.
https://richardscreativeworkshop.co.uk/waynes_commission/#barriers