Well, I finally got around to finishing those two little dios. I chucked a 3/16th drill bit into the cordless and drilled a couple of holes through the groundwork and into the wooden base of each dio. I then clipped a couple of lengths of some 16GA coated tie wire and superglued one in each hole. After the glue dried, I snipped each length off to the size of a foot peg and then touched em up with acrylic paint. I also touched up the outer edge of each dio, where I cut off the protective tape, where the ground work met the wooden base, just to pretty em up a bit.
I am going to ship these two out into the world tomorrow but before I do, I wanted to take some shots with a couple of my favorite figure projects of the year.
On the reddish rocky dio is the 501st GM that was done not too long ago.