Hi All,
Did some more work on this today, I added the thick pipes by stripping out an old electric cord and then cut the lengths I wanted and made small holes and then inserted the cord and super glued them in place. The thinner pipes on top of the roof are pieces of plasti card and the thinner pipe on the back wall is what I pulled out of the electric cord.
The lights on the wall were made by using the left over joint pieces from the Bandai Star Wars figures and the glass piece is a Figma stand that come with their Indy figure. The stand piece is hollow so inserted the bulb into it and then cut a hole in the joint piece and glued the two together.
I connected them to the wall by drilling thru the wall and pushed thru the wiring and made another hole to attach the lights as the joint piece has a small rod connected to it.
The back wall has the machines that I made from plasti card, 1/72nd, 1/35th and 1/6th scale pieces. I added more pipes at the back to house the wiring from the bulbs and the machine on the left hand side houses the 9 volt battery.
The chairs were finally completed by using plasti card and a piece of foam for the bottom to raise the chairs up. The pipes on the inside of the roof are again pieces of plasti card rod which were glued together using model glue and once dry I used super glue to attach them to the roof.
All I have to do now is paint it and attach it to a base.
Ron
